Garmin CATALYST Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Garmin CATALYST. Garmin CATALYST 18 pages. Driving performance optimizer
Également pour Garmin CATALYST : Manuel du propriétaire (34 pages)

Imprimer la page

Place the filter firmly onto the camera lens.

Verify the line on the outer rim of the filter

the Garmin logo is right side up.

Removing the Polarising Filter from the Camera

Firmly grip the camera in one hand and the polarising filter in

the other hand.

Pull the filter away from the camera.

Installing the Remote Cam on Your

Windscreen

The adhesive mount is intended for a long-term installation and

can be difficult to remove. You should carefully consider the

mounting location before you install the mount.

Before you can install the adhesive mount onto your

windscreen, you should review the windscreen mounting

considerations

(Camera Mounting Considerations, page

For the best results, the ambient temperature should be from

21° to 38°C (from 70° to 100°F) while installing the camera on

your windscreen. The adhesive may not bond correctly if the

temperature is outside this range. If you need to install the

camera at lower temperatures, you must clear all snow, ice and

moisture from the windscreen and warm the windscreen using

the vehicle defroster before installing the camera.

The camera attaches to the windscreen using the included

adhesive mount.

Clean the inside of the windscreen using water or alcohol and

a lint-free cloth.

The windscreen must be free of dust, wax, oils and coatings.

Hold the camera in the desired mounting location on the

windscreen and verify the camera has a clear, unimpeded

view.

is facing up and

NOTICE

TIP: for best results, you should mount the camera as high

as possible in the centre of the windscreen.

After you have selected a mounting location with a clear

view, remove the protective film from the mount adhesive.

Position the mount over the mounting location.

TIP: the adhesive is extremely sticky. Avoid touching the

adhesive to the windscreen until the mount is properly

positioned.

Press the mount firmly onto the windscreen and maintain

pressure for 30 seconds.

This helps to ensure the mount adhesive has proper contact

with the windscreen.

Connecting the Camera Cable

Plug the camera cable into the micro-USB port on the

camera.

1).

Route the camera cable around your windscreen so it does

not obstruct your view of the track.

Installation