Garmin GPSMAP 800 Series Manuel de démarrage rapide - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Garmin GPSMAP 800 Series. Garmin GPSMAP 800 Series 17 pages. Flat-mount kit
Également pour Garmin GPSMAP 800 Series : Addendum au manuel du pilote (22 pages), Manuel du propriétaire (40 pages), Manuel de démarrage rapide (4 pages), Manuel du propriétaire (46 pages), Manuel d'instructions d'installation (6 pages), Manuel de l'opérateur (32 pages), Manuel d'instructions d'installation (34 pages), Manuel d'instructions d'installation (6 pages)

Imprimer la page
Garmin GPSMAP 800 Series Manuel de démarrage rapide
The spoke magnet can face away
from the GSC 10 if there is not
enough room between the sensor
arm and the spoke. The spoke
magnet must line up with the
indication line
arm.
6. Loosen the screw
arm.
7. Move the sensor arm to within
5 mm of the spoke magnet.
You can also tilt the GSC 10 closer
to either magnet for improved
alignment.
8. Press the Reset key
GSC 10.
The LED turns red, then green.
8
on the sensor
➑
on the sensor
➒
on the
➓
9. Pedal to test the sensor alignment.
The red LED blinks each time the
pedal magnet passes the sensor.
The green LED blinks each time
the spoke magnet passes the sensor
arm.
NOTE: The LED blinks for
the first 60 passes after a reset.
Press Reset again if you require
additional passes.
10. When everything is aligned and
working correctly, tighten the cable
ties, the sensor arm, and the spoke
magnet.
Garmin recommends that the torque
is 1.9 to 2.4 lbf-in to ensure a water
tight seal on the GSC 10 sensor
arm.
When the GSC 10 is paired, a message
appears, and
the status page.
Edge 800 Quick Start Manual
appear solid on