Garmin GPSMAP 800 Series 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Garmin GPSMAP 800 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPSMAP 800 Series 17 페이지. Flat-mount kit
Garmin GPSMAP 800 Series에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (22 페이지), 소유자 매뉴얼 (40 페이지), 빠른 시작 매뉴얼 (4 페이지), 소유자 매뉴얼 (46 페이지), 설치 지침 매뉴얼 (6 페이지), 운영자 매뉴얼 (32 페이지), 설치 지침 매뉴얼 (34 페이지), 설치 지침 매뉴얼 (6 페이지)

페이지 인쇄
Garmin GPSMAP 800 Series 빠른 시작 매뉴얼
The spoke magnet can face away
from the GSC 10 if there is not
enough room between the sensor
arm and the spoke. The spoke
magnet must line up with the
indication line
arm.
6. Loosen the screw
arm.
7. Move the sensor arm to within
5 mm of the spoke magnet.
You can also tilt the GSC 10 closer
to either magnet for improved
alignment.
8. Press the Reset key
GSC 10.
The LED turns red, then green.
8
on the sensor
➑
on the sensor
➒
on the
➓
9. Pedal to test the sensor alignment.
The red LED blinks each time the
pedal magnet passes the sensor.
The green LED blinks each time
the spoke magnet passes the sensor
arm.
NOTE: The LED blinks for
the first 60 passes after a reset.
Press Reset again if you require
additional passes.
10. When everything is aligned and
working correctly, tighten the cable
ties, the sensor arm, and the spoke
magnet.
Garmin recommends that the torque
is 1.9 to 2.4 lbf-in to ensure a water
tight seal on the GSC 10 sensor
arm.
When the GSC 10 is paired, a message
appears, and
the status page.
Edge 800 Quick Start Manual
appear solid on