Garmin GPS 17 Series Manuel d'instructions d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GPS 17 Series. Garmin GPS 17 Series 16 pages. Technical specifications
Également pour Garmin GPS 17 Series : Manuel d'instructions d'installation (17 pages), Manuel d'instructions d'installation (19 pages), Spécifications techniques (37 pages)

Flush Mounting the GPSMAP 2106/2110

Tools

• Flush Mount Template

• Jig saw

• Masking tape

• Scissors

• Drill

• Drill bits—1/8" (3 mm) and 3/8" (6 mm)

• 1/16" (2 mm) Allen (Hex) wrench

• Sockets or wrenches

• Hammer

• Center punch

To ﬂush mount the GPSMAP 2106/2110:

1. Trim the Flush Mount Template, and tape it in the location you want.

2. Using the center punch, indent the center of each mounting hole location.

3. Using an 1/8" (3 mm) drill bit, drill the four mounting holes.

4. Using a 3/8" (6 mm) drill bit, drill a hole to begin cutting the mounting surface.

5. Using the jig saw, cut the mounting surface along the inside of the dashed line indicated on the template. Use a ﬁle and sandpaper to

reﬁne the size of the hole. Be very careful when cutting this hole. There is only a small amount of clearance between the case

molding and the mounting holes.

6. Install the four mounting studs into unit by screwing the shorter, threaded section into the back of the unit. Use a 1/16" (2 mm) Allen

wrench to tighten the mounting studs until the stop contacts the case. Be careful not to overtighten because this may damage the

mounting stud! The studs have a reusable thread-locking patch

pre-applied from the factory.

7. Place the unit into the cut-out of the mounting surface.

8. Place washers over the mounting studs, then thread on one

hex nut per mounting stud. Tighten all four until the unit is snug

against the mounting surface. Install and tighten the second hex

nut set on all four mounting studs to lock the ﬁrst set in place.

��

Flush Mount Template

GPSMAP 2106/2110 & GPS 17

230mm

208mm

Flush Mount

Stud

Washer Hex nuts

NSTALLATION

NSTRUCTIONS

Mounting surface