Garmin TR-1 Gold Manuel du propriétaire - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Garmin TR-1 Gold. Garmin TR-1 Gold 38 pages. Throttle actuator
Également pour Garmin TR-1 Gold : Manuel d'utilisation de base (9 pages), Référence rapide (2 pages), Instructions de montage (7 pages), Instructions d'installation (4 pages), Référence rapide de l'ordinateur de poche du propriétaire (2 pages)

Fig. 9-A

Fig. 10-b

Run the wire back to the E-H unit. The wire connector from the Sensor Ball is labeled number

4. It connects to the E-H unit at connector 4, as shown in fig.10-a or 10-b. (this will depend on

your ECU wiring configuration). When you plug in the connectors, the wires go at about a 45 -

angle left of the numbers on the E-H unit (fig. 10-a) or at a 90° angle for fig 10-b. Feel the

connectors start before pushing it down.

Fig. 10-a

Step 3 (Adjusting Sensor Ball)

Readjust the ball if necessary and fix

it in position by tightening the

thumbscrew. See Fig 9-A. Make

sure that the wires from the Sensor

Ball are pointing straight down out

the bottom; otherwise the sensor ball

will not work properly. See Fig. 9-B

Note: It is important to match

your ECU wiring configuration

to the picture. Just remember

to always plug into matching

numbers from the wire to the

ECU.

Fig. 9-B