Garmin TR-1 Gold 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Garmin TR-1 Gold에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 38 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (7 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)

페이지 인쇄

Fig. 9-A

Fig. 10-b

Run the wire back to the E-H unit. The wire connector from the Sensor Ball is labeled number

4. It connects to the E-H unit at connector 4, as shown in fig.10-a or 10-b. (this will depend on

your ECU wiring configuration). When you plug in the connectors, the wires go at about a 45 -

angle left of the numbers on the E-H unit (fig. 10-a) or at a 90° angle for fig 10-b. Feel the

connectors start before pushing it down.

Fig. 10-a

Step 3 (Adjusting Sensor Ball)

Readjust the ball if necessary and fix

it in position by tightening the

thumbscrew. See Fig 9-A. Make

sure that the wires from the Sensor

Ball are pointing straight down out

the bottom; otherwise the sensor ball

will not work properly. See Fig. 9-B

Note: It is important to match

your ECU wiring configuration

to the picture. Just remember

to always plug into matching

numbers from the wire to the

ECU.

Fig. 9-B