Garmin TR-1 Gold 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Garmin TR-1 Gold에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 38 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (7 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)

페이지 인쇄

The Sensor (Compass) Ball needs to be mounted forward of the center of your boat. Make sure

you mount it away from magnetic disturbances (stereo speakers, wiper motors, anchors). You

will need to calibrate your compass on the water after installation of system and before you use

the autopilot.

Fig. 8-a

Fig. 8-b

Installation of the Sensor Ball

Step one (Mounting the Sensor Ball)

Hold the mounting bracket in the desired

position and drill through the holes into the

mounting surface. (Be sure that the wire

coming out of the ball can exit the ball

straight down.) Tap if necessary. Install and

tighten the three mounting screws as shown

in fig.8-a

If you need to make a paper template for a

drill pattern: The mounting holes are equally

s p aced on a 1.224 inch radius circle.

Step two (Placing ball in bracket)

Place the ball, wires down, into the

bracket and capture it by snapping the

cage over the ball, sliding the tips of the

cage between the ball and the legs of the

bracket. Do the two legs without the

thumbscrew first. Rotate cage upwards to

catch the bracket with the thumbscrew.

See fig. 8-b