Garmin TR-1 Gold 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Garmin TR-1 Gold에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 38 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (7 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)

페이지 인쇄

Before you start.........

As with all hydraulic systems, it is very important to keep any dirt or debris from entering

the system.

If you haven't already, loosen the steering tension adjustment on your motor to the minimum

setting. The motor should turn very easily. (If necessary refer to your outboard motor's

owner's manual).

The fittings in the electro hydraulic unit (Pump unit) and the Cylinder are barbed hose fittings.

It is important that you push the hose completely over the barbs. Use some fluid to lube the inside

of hose before pushing them on. It will make the process slightly easier.

This process may be a little messy so keep a few rags handy. Safety glasses are also a good idea.

Step One

Remove the Left side of the kinked clear shipping tube from

the E-H unit. Keep the kinked clear tube (with the tie wrap)

on the Right barbed fitting (It will act as a plug).Fig.A

Step Two

Run a continuous section of black rubber hose from the Left

E-H fitting, out the back of the boat to the cylinder and back

into the boat to the pump. Do not cut the hose at this time.

See.Fig. B

Connect and Fill the Hydraulic System

Fig. B

Fig A

Fig. A