Garmin TR-1 Gold 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Garmin TR-1 Gold에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 38 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (7 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)

페이지 인쇄

Slide the rod into the cylinder as far as it will go. Now remove the short clear hose from the cylinder and

drain the fluid from the tubing into the bottle. Be sure both cylinder fittings are full to the top. Point the

rod end of the cylinder toward the pin that engages it but leave it pushed into the cylinder.

Fig. 16

Fig. 17

Fig. 17-A

Step Six (Fill Cylinder)

You will need the motor in the down position and

the cylinder fittings pointing straight up.

Disconnect the rod end of the cylinder from its

mount. Find the kinked piece of tubing that you

removed in step one. Remove the tie wrap and cut

the tubing in half. Push one half on each cylinder

barbed fitting. Open the fluid bottle. Insert pieces

of tubing into the fluid. They need to go to the

bottom of the bottle. Now hold the tubing in the

bottle with one hand and pull and push the rod in

and out of the cylinder until you stop seeing air

bubbles in the hose. Refer to fig. 16

Step Seven (Correctly connect the hose)

At the cylinder, kink the black hose (bend it

over sharply and use a tie wrap to pinch hose

shut). See Fig. 17. Cut the hose as shown just

above the tie wrap and keep a thumb over the

right side to keep the fluid in the hose. Keep

the hose full to the brim and push the right

hose (hose that has tape) onto the right cylinder

fitting as shown in Fig.17-A

Cut the tie wrap on the left hose and insert it on

the left fitting on the cylinder as shown in

Fig.17-B. Reconnect the cylinder rod end.

Fig. 17-B