Garmin TR-1 Gold Panduan Pemilik - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem GPS Kelautan Garmin TR-1 Gold. Garmin TR-1 Gold 38 halaman. Throttle actuator
Juga untuk Garmin TR-1 Gold: Panduan Pengoperasian Dasar (9 halaman), Referensi Cepat (2 halaman), Petunjuk Pemasangan (7 halaman), Petunjuk Instalasi (4 halaman), Referensi Cepat Genggam Pemilik (2 halaman)

Garmin TR-1 Gold Panduan Pemilik
Before you start.........
As with all hydraulic systems, it is very important to keep any dirt or debris from entering
the system.
If you haven't already, loosen the steering tension adjustment on your motor to the minimum
setting. The motor should turn very easily. (If necessary refer to your outboard motor's
owner's manual).
The fittings in the electro hydraulic unit (Pump unit) and the Cylinder are barbed hose fittings.
It is important that you push the hose completely over the barbs. Use some fluid to lube the inside
of hose before pushing them on. It will make the process slightly easier.
This process may be a little messy so keep a few rags handy. Safety glasses are also a good idea.
Step One
Remove the Left side of the kinked clear shipping tube from
the E-H unit. Keep the kinked clear tube (with the tie wrap)
on the Right barbed fitting (It will act as a plug).Fig.A
Step Two
Run a continuous section of black rubber hose from the Left
E-H fitting, out the back of the boat to the cylinder and back
into the boat to the pump. Do not cut the hose at this time.
See.Fig. B
Connect and Fill the Hydraulic System
Fig. B
15
15
Fig A
Fig. A