Garmin TR-1 Gold Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Morski system GPS Garmin TR-1 Gold. Garmin TR-1 Gold 38 stron. Throttle actuator
Również dla Garmin TR-1 Gold: Podstawowa instrukcja obsługi (9 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja montażu (7 strony), Instrukcje instalacji (4 strony), Skrócona instrukcja obsługi (2 strony)

The Sensor (Compass) Ball needs to be mounted forward of the center of your boat. Make sure

you mount it away from magnetic disturbances (stereo speakers, wiper motors, anchors). You

will need to calibrate your compass on the water after installation of system and before you use

the autopilot.

Fig. 8-a

Fig. 8-b

Installation of the Sensor Ball

Step one (Mounting the Sensor Ball)

Hold the mounting bracket in the desired

position and drill through the holes into the

mounting surface. (Be sure that the wire

coming out of the ball can exit the ball

straight down.) Tap if necessary. Install and

tighten the three mounting screws as shown

in fig.8-a

If you need to make a paper template for a

drill pattern: The mounting holes are equally

s p aced on a 1.224 inch radius circle.

Step two (Placing ball in bracket)

Place the ball, wires down, into the

bracket and capture it by snapping the

cage over the ball, sliding the tips of the

cage between the ball and the legs of the

bracket. Do the two legs without the

thumbscrew first. Rotate cage upwards to

catch the bracket with the thumbscrew.

See fig. 8-b