Garmin TR-1 Gold Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Garmin TR-1 Gold. Garmin TR-1 Gold 38 pages. Throttle actuator
Également pour Garmin TR-1 Gold : Manuel d'utilisation de base (9 pages), Référence rapide (2 pages), Instructions de montage (7 pages), Instructions d'installation (4 pages), Référence rapide de l'ordinateur de poche du propriétaire (2 pages)

Imprimer la page

E-H unit

Sensor Ball

Remote

Deckmount/Tach

Battery Cable

Fluid

Supply Voltage

Maximum Current

Inline Fuse

Operating Ambient Temperature

This manual comprises two major sections. The first section is a guide to installation of

the "onboard" components of the autopilot system on your boat. The second section is a

guide to adjusting and operating your system. Installation instructions for the throttle

actuator and steering cylinder are motor specific and are provided in separate manuals.

You will be hard mounting three autopilot components in your boat: 1) The Electrohydraulic

Unit. 2) The Deckmount switch. 3) The Sensor ball. These components are shown in relation

to each other and to the engine mounted components in the System Layout diagram on page 8.

As indicated by this diagram, the Electrohydraulic unit and the Deckmount switch are to be

located near the kicker and the Sensor ball is to be located FORWARD OF THE CENTER

OF YOUR BOAT

Spend some time to figure out where you are going to mount all of the components before you

mount any of them. Place the components where you expect to mount them and verify you

have access to and routes for the cables and hoses that connect the components.

Mounting Screws

Mounting screws are provided for through and blind hole applications. You may choose

to drill and tap the mounting surface.

SCREW

#8 – 32 machine

#8 sheet metal

TR-1 Gold Specifications

6.5"H x 7" W x 5" D

3.6" Dia.

Cable length 18'

5"x 2.5"x 1" Cable length 18'

5/8"x 2"

Cable length 6'

Cable length 9'

1 pt.

BioSOY Oil

11.5 – 14.0

VDC

Amperes

ATO 20 Amp

Introduction

Preparation

TAP DRILL

#29 .136 dia

20 – 120 deg F

TAP

CLEARANCE

#8 –32

3/16

8 lb

2 lb

1 lb

PILOT

1/8