Garmin TR-1 Gold 소유자 매뉴얼 - 페이지 6
{카테고리_이름} Garmin TR-1 Gold에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin TR-1 Gold 38 페이지. Throttle actuator
Garmin TR-1 Gold에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (9 페이지), 빠른 참조 (2 페이지), 설치 지침 (7 페이지), 설치 지침 (4 페이지), 소유자 핸드헬드 빠른 참조 (2 페이지)
페이지 인쇄
E-H unit
Sensor Ball
Remote
Deckmount/Tach
Battery Cable
Fluid
Supply Voltage
Maximum Current
Inline Fuse
Operating Ambient Temperature
This manual comprises two major sections. The first section is a guide to installation of
the "onboard" components of the autopilot system on your boat. The second section is a
guide to adjusting and operating your system. Installation instructions for the throttle
actuator and steering cylinder are motor specific and are provided in separate manuals.
You will be hard mounting three autopilot components in your boat: 1) The Electrohydraulic
Unit. 2) The Deckmount switch. 3) The Sensor ball. These components are shown in relation
to each other and to the engine mounted components in the System Layout diagram on page 8.
As indicated by this diagram, the Electrohydraulic unit and the Deckmount switch are to be
located near the kicker and the Sensor ball is to be located FORWARD OF THE CENTER
OF YOUR BOAT
Spend some time to figure out where you are going to mount all of the components before you
mount any of them. Place the components where you expect to mount them and verify you
have access to and routes for the cables and hoses that connect the components.
Mounting Screws
Mounting screws are provided for through and blind hole applications. You may choose
to drill and tap the mounting surface.
SCREW
#8 – 32 machine
#8 – 32 machine
#8 sheet metal
TR-1 Gold Specifications
6.5"H x 7" W x 5" D
3.6" Dia.
Cable length 18'
5"x 2.5"x 1" Cable length 18'
5/8"x 2"
Cable length 6'
Cable length 9'
1 pt.
BioSOY Oil
11.5 – 14.0
VDC
12
Amperes
ATO 20 Amp
Introduction
Preparation
TAP DRILL
#29 .136 dia
6
20 – 120 deg F
TAP
CLEARANCE
#8 –32
3/16
6
8 lb
2 lb
1 lb
1 lb
PILOT
1/8