Garmin GHP 10V Manuel d'instructions d'installation - Page 16
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GHP 10V. Garmin GHP 10V 20 pages. Marine autopilot system
Également pour Garmin GHP 10V : Manuel d'instructions d'installation (48 pages), Manuel du propriétaire (28 pages), Manuel d'instructions d'installation (20 pages)
Imprimer la page
Category
Navigation Setup > NMEA Setup
Navigation Setup > NMEA Setup
Navigation Setup
Navigation Setup
note: Certain configuration settings are available when using the GHC 10 normally, such as enabling and disabling the Shadow Drive, adjusting the
sensitivity of the Shadow Drive, and adjusting the Sea State Filtering setting. See the configuration section of the GHC 10 Quick Start Manual for more
information.
16
Setting
Description
NMEA Checksum
If the connected GPS unit incorrectly calculates checksums, you may
still be able to use it if you turn this setting off. When off, data integrity is
compromised.
Reversed XTE
If the connected GPS unit sends the incorrect steering direction with the
cross-track error signal, use this setting to correct the steering direction.
Navigation Gain
Because the cross-track error data transmitted by a NMEA 0183 GPS
device is only accurate within .01 mile (60 ft.), the gain may need
adjustment. Increase this setting until the boat oscillates back and forth
near the course line, then lower it a few levels.
Navigation Trim Gain
After adjusting the Navigation gain, increase this setting until you can see
the standoff from the course line decreasing over time.
GHP 10V Installation Instructions