Garmin GMR Fantom 126 Manuel d'instructions d'installation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Garmin GMR Fantom 126. Garmin GMR Fantom 126 19 pages.
Imprimer la page
Specifying the Antenna Size
Before you can use the radar on your system, you must specify the antenna size.
1 Turn on the radar and all devices connected to the Garmin Marine Network.
An antenna-selection prompt appears on the connected chartplotters.
NOTE: If the entire system is being turned on for the first time, the antenna-selection screen is part of the
initial setup process.
2 Select the installed antenna size for each open-array radar installed on the boat.
TIP: If you need to specify a different antenna size, while viewing the radar screen for the radar you want to
change, select Menu > Radar Setup > Installation > Antenna Configuration > Antenna Size, and select the
antenna size.
Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar
scanner does not align with the bow-stern axis.
Measuring the Potential Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar
scanner does not align with the bow-stern axis.
1 Using a magnetic compass, take an optical bearing of a stationary target located within viewable range.
2 Measure the target bearing on the radar.
3 If the bearing deviation is more than +/- 1°, set the front-of-boat offset.
Setting the Front-of-Boat Offset
Before you can set the front-of-boat offset, you must measure the potential front-of-boat offset.
The front-of-boat offset setting configured for use in one radar mode is applied to every other radar mode and
to the Radar overlay.
1 From a Radar screen or the Radar overlay, select Menu > Radar Setup > Installation > Front of Boat.
2 Select Up or Down to adjust the offset.
Setting a Custom Park Position
By default, the antenna is stopped perpendicular to the pedestal when it is not spinning. You can adjust this
position.
1 From the radar screen, select Menu > Radar Setup > Installation > Antenna Configuration > Park Position.
2 Use the slider bar to adjust the position of the antenna when stopped, and select Back.
13