Garmin GMR Fantom 126 Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Морское оборудование Garmin GMR Fantom 126. Garmin GMR Fantom 126 19 страниц.

Specifying the Antenna Size

Before you can use the radar on your system, you must specify the antenna size.

1 Turn on the radar and all devices connected to the Garmin Marine Network.

An antenna-selection prompt appears on the connected chartplotters.

NOTE: If the entire system is being turned on for the first time, the antenna-selection screen is part of the

initial setup process.

2 Select the installed antenna size for each open-array radar installed on the boat.

TIP: If you need to specify a different antenna size, while viewing the radar screen for the radar you want to

change, select Menu > Radar Setup > Installation > Antenna Configuration > Antenna Size, and select the

antenna size.

Front-of-Boat Offset

The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar

scanner does not align with the bow-stern axis.

Measuring the Potential Front-of-Boat Offset

The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the radar

scanner does not align with the bow-stern axis.

1 Using a magnetic compass, take an optical bearing of a stationary target located within viewable range.

2 Measure the target bearing on the radar.

3 If the bearing deviation is more than +/- 1°, set the front-of-boat offset.

Setting the Front-of-Boat Offset

Before you can set the front-of-boat offset, you must measure the potential front-of-boat offset.

The front-of-boat offset setting configured for use in one radar mode is applied to every other radar mode and

to the Radar overlay.

1 From a Radar screen or the Radar overlay, select Menu > Radar Setup > Installation > Front of Boat.

2 Select Up or Down to adjust the offset.

By default, the antenna is stopped perpendicular to the pedestal when it is not spinning. You can adjust this

position.

1 From the radar screen, select Menu > Radar Setup > Installation > Antenna Configuration > Park Position.

2 Use the slider bar to adjust the position of the antenna when stopped, and select Back.