Garmin Reactor 40 Manuel de configuration - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Garmin Reactor 40. Garmin Reactor 40 8 pages. Mechanical
Également pour Garmin Reactor 40 : Manuel d'instructions d'installation (11 pages), Manuel d'instructions d'installation (13 pages), Manuel d'instructions d'installation (29 pages), Manuel d'instructions d'installation (25 pages)

Imprimer la page

Garmin Reactor 40 Manuel de configuration

Performing the Dockside Wizard

1 Turn on the autopilot.

The first time you turn on the autopilot, you are prompted to complete a short setup sequence.

2 If the Dockside Wizard does not start automatically after the setup sequence, on a helm control or the

autopilot screen on a chartplotter, select

Dockside Wizard > Begin.

3 Test the steering direction

4 If necessary, select the speed source

5 Review the results of the Dockside Wizard

After you complete the Dockside Wizard, you must disable the Shadow Drive

autopilot system is not compatible with the Shadow Drive valve, and an error message appears until you disable

it.

Testing the Steering Direction

1 While sitting still or moving at a low rate of speed, select

When you select , the motor must turn the boat to the left. When you select , the motor must turn the boat

to the right.

2 Select an option:

• If the steering test turns the boat in the correct direction, select Next.

• If the steering test turns the boat in the opposite direction, select Switch Direction, and repeat steps 1

though 3.

Selecting a Speed Source

Select an option:

• If you connected the spark plug wire on the throttle actuator to a spark plug cable on the motor, select

Tach. - N2K or Proprietary.

• If you did not connect the spark plug wire on the throttle actuator, select GPS as a speed source.

NOTE: Garmin

recommends using an external GPS antenna mounted with a clear view of the sky to

provide reliable and accurate GPS speed information.

• If you did not connect the spark plug wire on the throttle actuator, or do not have a GPS device as a speed

source, select None.

NOTE: If the autopilot does not perform well using None as the speed source, Garmin recommends

connecting the spark plug wire on the throttle actuator or using an external GPS antenna as the speed

source.

Reviewing the Results of the Dockside Wizard

The values you chose when you ran the Dockside Wizard are displayed.

1 Examine the results of the Dockside Wizard.

2 Select any incorrect value.

3 Correct the value.

4 Repeat steps 2 and 3 for all incorrect values.

5 When you are finished reviewing the values, select Done.

Disabling the Shadow Drive Valve

After you complete the Dockside Wizard, you must disable the Shadow Drive valve in the settings. This autopilot

system is not compatible with the Shadow Drive valve, and an error message appears until you disable it.

On a helm control or the autopilot screen on a chartplotter, select

Setup > Shadow Drive.

The Shadow Drive field shows a status of Disabled.

> Autopilot Setup > Autopilot Installation Setup > Wizards >

(Testing the Steering Direction,

(Selecting a Speed Source,

(Reviewing the Results of the Dockside Wizard,

page 2).

valve in the settings. This

™

and .

> Autopilot Setup > Shadow Drive

page 2).