AEG 3531 WK-m Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} AEG 3531 WK-m. AEG 3531 WK-m 12 pages. Electrolux cooktop user manual
Également pour AEG 3531 WK-m : Manuel d'instruction (24 pages), Manuel d'instruction (10 pages)

Imprimer la page

Any adjoining wall surface situated

within 200 mm from the edge of

any hob burner must be a suitable

noncombustible material for a

height of 150 mm for the entire

length of the hotplate.

Any combustible construction

above the hotplate must be at least

600 mm above the top of the burner

and no construction shall be within

450 mm above the top of burner. A

minimum depth of 60 mm from the

top of the worktop surface must be

provided for the hotplate.

Cut-out measurements

One rectangular hole is sawn out for

the hob combination chosen.

The depth of the cut-out for any unit

is: 490 mm length of hole = sum of

all units` externally measured

length, less 20 mm. If the appliance

is to be installed as a single unit

then the length of the hole shoul be

the length of the unit less 18 mm.

Mounting of Reinforcement

Beams

A reinforcement Beam, with

supporting flanges at each end, is

included with each two-burner unit.

For unit combinations, a

reinforcement beam must be used

between each unit.

It is not necessary to attach the

reinforcement beam to the table

surface, as it is held in place by a

specially designed moulding, which

is incorporated in the hob units

flanges.

Minimum distance

Minimum

distance

to back wall (non-

to side wall:

flammable material):

150 mm

50 mm

Reinforcement

beams

Cleaning and maintenance

For reasons of hygiene and

safety, the cooking burner

must be kept clean.

Grease stains and spilled

food generate smoke when

heated, and can even cause

fire.

Splashguard

The splashguard can be removed to

make it easier to clean the surface.

What to do:

1. Hold the splashguard as shown

in the diagram.

2. Lift the splashguard straight up

3. Clean the top surface as

described in "cleaning the steel

surface".

Be aware of the two retaining

pegs, which are sharp.

4. Replace the splashguard in

position ENSURE that it is

fitted the correct way round.

Never use hard or sharp

implements to lift off the

splashguard.

Do not wash the splashguard

in a dishwasher.

The hob must not be used

with the splashguard off.