Brother MFC-T910DW Manuel de référence - Page 27

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} Brother MFC-T910DW. Brother MFC-T910DW 30 pages. Brief explanations for routine operations
Également pour Brother MFC-T910DW : Manuel de sécurité des produits (24 pages), Manuel d'installation rapide (2 pages), Manuel de référence (29 pages)

Imprimer la page
Brother MFC-T910DW Manuel de référence

Wireless LAN Report Error Codes

If the Wireless LAN Report shows that the connection failed, check the error code on the printed
report and see the corresponding instructions in the table:
Error Code
Problem and Recommended Solutions
TS-01
The wireless setting is not activated. Change the wireless setting to ON.
If a network cable is connected to your machine, disconnect it and change the
wireless setting of your machine to ON.
TS-02
The wireless access point/router cannot be detected. Do one of the following:
• Unplug the power to your wireless access point/router, wait for 10 seconds,
and then plug it back in.
• If your WLAN access point/router is using MAC address filtering, confirm
that the MAC address of the Brother machine is allowed in the filter.
• Check that you are selecting the correct SSID (network name) and are
entering the correct network key.
TS-04
Unsupported authentication/encryption method has been detected on your
wireless access point/router.
Your wireless access point/router is using an authentication/encryption method
that is not supported by the device. Check that you are selecting the correct
SSID (network name).
TS-05
The specified SSID and network key are incorrect.
Check that you are selecting the correct SSID (network name) and are
entering the correct network key.
TS-06
The specified wireless security information is incorrect.
Check the authentication/encryption method that you are selecting and make
sure you are entering the correct network key.
TS-07
The machine cannot detect a wireless access point/router that has WPS
enabled.
To configure your wireless settings using WPS, confirm that your wireless
access point/router supports WPS and try again.
TS-08
Two or more wireless access points that have WPS enabled are detected.
Try again after a few minutes to avoid interference from other access points.
21