Brother MFC-T910DW Manuale di riferimento - Pagina 27

Sfoglia online o scarica il pdf Manuale di riferimento per Stampante All in One Brother MFC-T910DW. Brother MFC-T910DW 30. Brief explanations for routine operations
Anche per Brother MFC-T910DW: Manuale di sicurezza del prodotto (24 pagine), Manuale di configurazione rapida (2 pagine), Manuale di riferimento (29 pagine)

Wireless LAN Report Error Codes

If the Wireless LAN Report shows that the connection failed, check the error code on the printed

report and see the corresponding instructions in the table:

Error Code

Problem and Recommended Solutions

TS-01

The wireless setting is not activated. Change the wireless setting to ON.

If a network cable is connected to your machine, disconnect it and change the

wireless setting of your machine to ON.

TS-02

The wireless access point/router cannot be detected. Do one of the following:

• Unplug the power to your wireless access point/router, wait for 10 seconds,

and then plug it back in.

• If your WLAN access point/router is using MAC address filtering, confirm

that the MAC address of the Brother machine is allowed in the filter.

• Check that you are selecting the correct SSID (network name) and are

entering the correct network key.

TS-04

Unsupported authentication/encryption method has been detected on your

wireless access point/router.

Your wireless access point/router is using an authentication/encryption method

that is not supported by the device. Check that you are selecting the correct

SSID (network name).

TS-05

The specified SSID and network key are incorrect.

Check that you are selecting the correct SSID (network name) and are

entering the correct network key.

TS-06

The specified wireless security information is incorrect.

Check the authentication/encryption method that you are selecting and make

sure you are entering the correct network key.

TS-07

The machine cannot detect a wireless access point/router that has WPS

enabled.

To configure your wireless settings using WPS, confirm that your wireless

access point/router supports WPS and try again.

TS-08

Two or more wireless access points that have WPS enabled are detected.

Try again after a few minutes to avoid interference from other access points.