AEG 6530 DG-M Manuel d'instruction et d'installation - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et d'installation pour {nom_de_la_catégorie} AEG 6530 DG-M. AEG 6530 DG-M 12 pages. Electrolux user information gas hob
Également pour AEG 6530 DG-M : Manuel d'instruction et d'installation (25 pages)
Imprimer la page
Connection to the gas supply
should be with either rigid or semi-
rigid pipe, i.e. steel or copper.
The connection should be suitable
for connection to RC ½ (½ BSP
male conical thread).
When the final connection has been
made, it is essential that a thorough
leak test is carried out on the hob
and installaion.
Ensure that the main connection
pipe does not exert any strain on
the hob.
It is important to install the
elbow correctly, with the
shoulder on the end of the
thread, fitted to the hob
connection pipe.
Failure to ensure to correct
assembly will cause leakage
of gas.
Pressure test
The unit should be pressure-tested
at Max. 150 mbar.
14
Cleaning of gas burners
Clean the control panel and knobs plus
the pan grid, as well as burner caps and
rings, with ordinary cleansing agents.
Never use scouring powder, Brillo
pads, metal pads or other scouring
agents on enamelled or painted
surfaces!
Avoid boil-over
If water accidentally gets into the edge
of the burner head (boil-over) the
water must be removed with a lint-free
cloth before the burner is turned on
again.
Likewise, caps and grids must be
thoroughly wiped off before the gas
ring is used again so that the boil-over
does not permanently scar the enamel
or paint.
11