Brother P-touch PT-D610BT Manuel - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Brother P-touch PT-D610BT. Brother P-touch PT-D610BT 9 pages.
Également pour Brother P-touch PT-D610BT : Manuel (9 pages), Manuel de démarrage rapide (9 pages)
Imprimer la page
Problem
Solution
Previously saved label files
All files saved in the internal memory are deleted if the batteries are
are not available.
weak or the AC Adapter is disconnected.
• I cannot install the Printer
If you cannot use your Label Maker even though you have installed the
Driver even if I follow
Printer Driver:
the correct procedure
1. Download the Printer Driver Uninstaller from your model's page at
(Windows only).
support.brother.com.
• I cannot see my printer
2. Use the Printer Driver Uninstaller to remove the printer information.
listed in P-touch Editor
3. Run the Printer Driver Installer again and follow the on-screen
even though I have
instructions to proceed with the installation.
installed the Printer Driver
(Windows only).
The ink ribbon is separated
If the ink ribbon is broken, replace the Tape Cassette.
from the ink roller.
If it is not, leave the tape uncut and carefully remove
the Tape Cassette, and then wind the loose ink ribbon
back onto the spool.
Printed barcodes or QR
• Change the tape. (Recommended: Black on white tape)
codes cannot be read.
• Enlarge the barcodes or QR codes in the application you are using.
I do not know the firmware
Check the firmware information by pressing the following keys:
version of the Label Maker.
/
The font is already the maximum size for the width of the label. Or, the
The font size cannot be
label length has been set, so there is a limit on the font size to prevent
increased.
exceeding the set length.
When Chain Print is enabled, feed the tape to eject the last printed
When multiple labels are
label.
printed, the last label is cut
incorrectly.
23 mm
[Settings]
/
[Version Information]
23 mm
Problem
When the label is printed,
there is too much margin
(space) on both sides of
the text.
Spool
I cannot update the printer's
firmware using the P-touch
Update Software, Transfer
Express, or Mac Update Tool.
Contact Information
Customer Service for Canada
www.brother.ca/support
To order supplies and accessories:
www.brother.ca/
DON'T FORGET TO REGISTER!
Registering your product will provide purchase confirmation, proof of ownership and, if you
choose, allow us to notify you of product enhancements and special offers!
You can register online at:
www.brother.ca/en/product-registration
LIMITED WARRANTY
Product warranty information can be found online at:
www.brother.ca/warranty
23 mm
Solution
• See the Set Margins section in this guide and select [Small
Margin], [Chain] or [No Cut] for smaller margins.
When you set [Small Margin], the Label Maker feeds approx.
23 mm of leader tape before every new label.
To save tape, select the [Chain] setting. After the last label prints,
press
and
simultaneously to feed and cut the tape.
• The Label Maker feeds approx. 23 mm of tape before every new
label. When printing multiple labels, you can reduce the blank
space on the second and subsequent labels.
Select the [Chain] setting in the optional print settings. Then, print
your labels and leave the last label in the Label Maker until you
are ready to print a new label.
• After the last label prints, press
and
feed the tape, and then eject and cut the last label. Note that the
Label Maker will feed approx. 23 mm of tape before the next new
label when you use this method.
Restart the printer and then try to update the firmware again. Do not
press any buttons during the firmware update.
simultaneously to