Brother Stampcreator PRO SC2000USB Référence rapide - Page 25
Parcourez en ligne ou téléchargez le pdf Référence rapide pour {nom_de_la_catégorie} Brother Stampcreator PRO SC2000USB. Brother Stampcreator PRO SC2000USB 36 pages.
Imprimer la page
f Fully insert the draft tray straight into the draft tray slot.
☞ Be careful not to pinch your fingers while inserting the draft tray.
To remove the draft tray, grab its outer case, then pull out the entire
draft tray.
After installing the ink ribbon cassette and the draft tray loaded with draft sheets, you can use P-touch Editor software
or Stampcreator Express software to create any layout containing graphics and text, and then engrave it into a stamp.
Engraving a stamp
a Turn on the SC-2000USB and start up the computer.
b Start up P-touch Editor and make sure that "SC-2000USB" is selected as the printer in the Print Setup dialog box ([Print
Setup] command in the [File] menu of the PC software).
c In the Page Format setting of the Page Properties, select the desired
stamp size, then design your stamp layout.
d Click the [Print] command in the [File] menu, select "Stamp" in the Print dialog box, then click the OK button. After
the data is printed onto the draft sheet, which is then fed over the xenon lamp, the message "INSTALL STAMP !"
appears on the LCD display of the SC-2000USB.
e Lift open the stamp compartment cover, slowly pull the lever toward
you to open the doors in the stamp compartment, and then check that
the printed draft sheet is stopped over the xenon lamp unit.
☞ Be careful not to touch the draft sheet that is stopped over the
xenon lamp unit.
Do not allow the clear plastic surface of the xenon lamp unit to
become dirty or scratched. Use a soft cloth to wipe off any dust on
the clear plastic surface.
To cancel engraving, press the Mode button on the SC-2000USB
until "CANCEL" appears on the display, then press the Set button to
feed out the draft sheet.
22
Draft tray
Draft tray slot
Stamp compartment cover
Lever
Doors