Brother Stampcreator PRO SC2000USB 빠른 참조 - 페이지 25

{카테고리_이름} Brother Stampcreator PRO SC2000USB에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother Stampcreator PRO SC2000USB 36 페이지.

f Fully insert the draft tray straight into the draft tray slot.

☞ Be careful not to pinch your fingers while inserting the draft tray.

To remove the draft tray, grab its outer case, then pull out the entire

draft tray.

After installing the ink ribbon cassette and the draft tray loaded with draft sheets, you can use P-touch Editor software

or Stampcreator Express software to create any layout containing graphics and text, and then engrave it into a stamp.

Engraving a stamp

a Turn on the SC-2000USB and start up the computer.

b Start up P-touch Editor and make sure that "SC-2000USB" is selected as the printer in the Print Setup dialog box ([Print

Setup] command in the [File] menu of the PC software).

c In the Page Format setting of the Page Properties, select the desired

stamp size, then design your stamp layout.

d Click the [Print] command in the [File] menu, select "Stamp" in the Print dialog box, then click the OK button. After

the data is printed onto the draft sheet, which is then fed over the xenon lamp, the message "INSTALL STAMP !"

appears on the LCD display of the SC-2000USB.

e Lift open the stamp compartment cover, slowly pull the lever toward

you to open the doors in the stamp compartment, and then check that

the printed draft sheet is stopped over the xenon lamp unit.

☞ Be careful not to touch the draft sheet that is stopped over the

xenon lamp unit.

Do not allow the clear plastic surface of the xenon lamp unit to

become dirty or scratched. Use a soft cloth to wipe off any dust on

the clear plastic surface.

To cancel engraving, press the Mode button on the SC-2000USB

until "CANCEL" appears on the display, then press the Set button to

feed out the draft sheet.

Draft tray

Draft tray slot

Stamp compartment cover

Lever

Doors