Fujitsu PRIMERGY BX900 Manuel de démarrage rapide - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Fujitsu PRIMERGY BX900. Fujitsu PRIMERGY BX900 22 pages. Blade server systems, fibre channel connection blade

Imprimer la page

Connecting the Embedded Switch Module to the fabric

NOTE

Refer to

"Cabling guidelines"

Before beginning the following steps, determine whether the Embedded Switch Module is in Brocade Access

Gateway or Fabric OS Native mode. This affects the configuration process.

1. If the Embedded Switch Module is in Fabric OS Native mode, continue with

Access Gateway mode, go on to

2. Log onto the Embedded Switch Module through a Telnet connection. For instructions on how to log on through a

Telnet connection, refer to

page 10.

3. Modify the domain ID, if required, using Embedded Switch Module CLI commands. Refer to the "Domain IDs"

section of the Fabric OS Administrator's Guide for more information.

NOTE

It could take a short time (typically a few seconds, but sometimes up to 20 seconds) for the newly added

Embedded Switch Module to appear in the fabric display with its newly-assigned domain ID.

4. If you need to install SFP transceivers, install them in the external Fibre Channel ports as required. The

transceivers are keyed to ensure correct orientation.

a. Ensure the transceiver is correctly oriented and, if necessary, remove the end caps from the SFP if the

transceiver does not install easily.

b. Orient the transceiver correctly and insert it into a port until it is firmly seated and the latching mechanism

clicks.

For instructions specific to the type of transceiver, refer to the transceiver manufacturer's documentation.

Repeat

step a

and

NOTE

Use only Brocade-branded SFPs on the external optical ports of this module.

5. Connect the cables to the transceivers.

The cables used in trunking groups must meet specific requirements. For a list of these requirements, see the

Fabric OS Administrator's Guide.

ATTENTION

A cable should not be bent to a radius less than 5.08 cm (2 inches) under full tensile load and 3.048 cm (1.2 inches)

with no tensile load.

Tie wraps are not recommended for optical cables because they are easily overtightened.

a. Orient a cable connector so that the key (the ridge on one side of connector) aligns with the slot in the

transceiver.

b. Insert the cable into the transceiver until the latching mechanism clicks. For instructions specific to cable

type, refer to the cable manufacturer's documentation.

Repeat for the remaining transceivers as required.

16 of 20

on page 4 before beginning the following procedure.

step

"Using the PRIMERGY BX900 Management Blade CLI to change system settings"

step b

for the remaining ports, as required.

step 2

and

step

Brocade 5450 Embedded Switch Module QuickStart Guide

Publication Number: 53-1001265-02

3. If the Module is in