Fujitsu ETERNUS AX Series Installation - Page 6

Parcourez en ligne ou téléchargez le pdf Installation pour {nom_de_la_catégorie} Fujitsu ETERNUS AX Series. Fujitsu ETERNUS AX Series 9 pages. Installing a cisco nexus 9336c-fx2 switch and pass-through panel in a cabinet, for cisco nexus 9336c-fx2 switches
Également pour Fujitsu ETERNUS AX Series : Manuel de démarrage rapide (8 pages)

Imprimer la page

1. With one person holding the front of the chassis level, the other person should fully tighten the four

rear screws to the cabinet posts.

c) With the chassis now supported without assistance, fully tighten the front screws to the posts.

d) Repeat steps

through

Note: By using the fully installed switch as a support, it is not necessary to hold the front of the second

switch during the installation process.

6. When the switches are installed, connect the jumper cords to the switch power inlets.

7. Connect the male plugs of both jumper cords to the closest available PDU outlets.

Note: To maintain redundancy, the two cords must be connected to different PDUs.

8. Connect the management port on each 9336C-FX2 switch to either of the management switches (if

ordered) or connect them directly to your management network.

The management port is the upper-right port located on the PSU side of the switch. The CAT6 cable for

each switch needs to be routed through the pass-through panel after the switches are installed to connect

to the management switches or management network.

| Installing a Cisco Nexus 9336C-FX2 switch and pass-through panel in a Fujitsu cabinet |

for the second switch at the RU42 location.