Fujitsu ETERNUS DX Disk Manuel de configuration - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 29 pages. Server connection, fcoe for linux driver settings for converged network adapter cards
Également pour Fujitsu ETERNUS DX Disk : Manuel de l'utilisateur (35 pages), Manuel de l'utilisateur (42 pages), Manuel de configuration (28 pages), Manuel de configuration (44 pages), Manuel de configuration (28 pages), Manuel de configuration (25 pages), Manuel de configuration (32 pages), Manuel de configuration (35 pages), Manuel de configuration (31 pages), Manuel de configuration (43 pages), Manuel de configuration (21 pages), Manuel de configuration (24 pages)

Imprimer la page
Fujitsu ETERNUS DX Disk Manuel de configuration
Chapter 4
Setting Up the Server
4.2

Creating a WWN Instance Management Table for Storage System

(3)
Enter the results in the "Physical slot name" column of the "WWN instance management table for
the server".
Example:
Physical slot name
SERV1_SLOT0
SERV1_SLOT1
This completes the "WWN instance management table for the server".
4.2
Creating a WWN Instance Management Table for Storage
System
Create a "WWN instance management table for storage system" (provided in
ment Table Templates" (page
age systems.
(Example) When there are two ports on the ETERNUS DX/AF storage systems:
Channel Adapter
CM0 CA0Port0
CM1 CA0Port0
Channel Adapter
•
CA name in the ETERNUS DX/AF storage systems
•
WWN
The WWN for each CA in the ETERNUS DX/AF (check using ETERNUSmgr or ETERNUS Web GUI)
Alias name
•
An arbitrarily-chosen alias name for each CA that may be used when setting up the fjpfca driver
This use of "alias name" differs from the "alias name" that is specified when setting Fibre Channel switch
zoning. However, it is recommended to set both aliases to the same name.
T_ID (SCSI target ID)
•
The SCSI target ID (decimal value) that is to be defined for each CA (check using ETERNUSmgr or ETERNUS
Web GUI)
For switch connections, the SCSI target ID is irrelevant to the physical protocol, however it must be defined
as a Solaris OS SCSI driver setting. Values matched to the server environment and connection state of the
devices must be set beforehand.
It is recommended to set the same target ID to CAs that configures a multipath.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Instance name
WWN
fjpfca0
100000000e248434
fjpfca1
100000000e24846f
25)) that summarizes information relating to CA in the ETERNUS DX/AF stor-
Alias name
WWN
DX400_CM0CA0P0
202000e000cb0001
203000e000cb0001
DX400_CM1CA0P0
12
Copyright 2017 FUJITSU LIMITED
Physical path name
/pci@4,2000/fibre-channel@1
/pci@6,4000/fibre-channel@2
"Appendix A Various Manage-
T_ID
16
16
P3AM-3712-15ENZ0