Fujitsu ETERNUS DX Disk Manuel de configuration - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 29 pages. Server connection, fcoe for linux driver settings for converged network adapter cards
Également pour Fujitsu ETERNUS DX Disk : Manuel de l'utilisateur (35 pages), Manuel de l'utilisateur (42 pages), Manuel de configuration (28 pages), Manuel de configuration (44 pages), Manuel de configuration (28 pages), Manuel de configuration (25 pages), Manuel de configuration (32 pages), Manuel de configuration (35 pages), Manuel de configuration (31 pages), Manuel de configuration (43 pages), Manuel de configuration (21 pages), Manuel de configuration (24 pages)

Imprimer la page
Fujitsu ETERNUS DX Disk Manuel de configuration
Chapter 4
Setting Up the Server
4.5
Re-checking the Settings
Incorrect setting example 2
•
Cables are not connected correctly.
#/usr/sbin/FJSVpfca/chk_conf -v
target 'fjpfca1t16'(alias=DX400_CM0) seems to be absent on fjpfca#1
target 'fjpfca2t17'(alias=DX400_CM1) seems to be absent on fjpfca#2
******************************
*port definition*
instance
------------------------------
fjpfca1
fjpfca2
*target definition*
instance
------------------------------------------------------------------------------
fjpfca1
fjpfca2
The following items can be confirmed by executing the "chk_conf" command:
-
Syntax check of general configuration file
Detailed syntax check relating to the following properties
-
alias
•
port
•
fcp-bind-target
•
Reference relationship between fcp-bind-target and alias
•
Whether or not the target device described in fcp-bind-target actually exists
•
2
Re-check target binding setting
By using the "chk_conf" command, you can check any errors in the configuration file, and check the Fi-
bre Channel cable physical connections. However, you cannot confirm whether or not target binding
based upon the system configuration has been performed correctly using the "chk_conf" command.
Re-check the following points before restarting the server.
•
Is the target binding set according to the system configuration?
•
Is the target binding table recorded according to the information in the WWN instance management
table?
Is "fjpfca.conf" set up according to the information of the target binding table?
•
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
status
options
found
nport
found
nport
t-id
wwn
16
0x213100e000cb0001
17
no binding
16
Copyright 2017 FUJITSU LIMITED
status
throt
alias
none
UNDEF
DX400_CM0CA0P0
none
UNDEF
DX400_CM1CA0P0
P3AM-3712-15ENZ0