Fujitsu ETERNUS DX Disk Manuel de configuration - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 21 pages. Server connection, fcoe for linux driver settings for converged network adapter cards
Également pour Fujitsu ETERNUS DX Disk : Manuel de l'utilisateur (35 pages), Manuel de l'utilisateur (42 pages), Manuel de configuration (28 pages), Manuel de configuration (44 pages), Manuel de configuration (28 pages), Manuel de configuration (29 pages), Manuel de configuration (25 pages), Manuel de configuration (32 pages), Manuel de configuration (35 pages), Manuel de configuration (31 pages), Manuel de configuration (43 pages), Manuel de configuration (24 pages)

Chapter 1

Setup Procedure for Emulex Converged Network Adapter Cards

1.3

Installing the Converged Network Adapter Card Driver

Instance name:

Not necessary to record.

Physical address:

Record the [Mem Base] value. This value can be confirmed in

Cable tag:

Record a tag name which indicates the connection path (relationship between the connected device

and the port).

Press the [Esc] key to quit the Emulex OneConnect FCoE BIOS Utility.

When installing two or more Converged Network Adapter cards to the server, first turn off the server,

then repeat

If multiple Converged Network Adapter cards are already installed in the server at the time of pur-

chase, the one-to-one relationship between the WWNs and the Converged Network Adapter cards

cannot be recognized. The WWNs that are obtained in this section may need to be repeatedly regis-

tered and set up on the ETERNUS DX until a server recognizes the ETERNUS DX logical disks.

For details about ETERNUS DX settings, refer to "Configuration Guide -Server Connection- Storage Sys-

tem Settings" that corresponds to the ETERNUS DX to be connected.

1.3

Installing the Converged Network Adapter Card Driver

Check whether the Converged Network Adapter card driver is the OS standard driver or not. If the Converged

Network Adapter card requires a non-standard driver, check the driver versions using the "Server Support Ma-

trix".

When the Converged Network Adapter card requires a standard kernel package driver

•

The standard add-on driver for the OS should be used.

When the Converged Network Adapter card requires a non-standard driver

•

Download and install the driver specified in the "Server Support Matrix" from the Emulex Corp. web-site.

Installation of applications, such as OneCommand Manager, is also required. Refer to the Emulex Con-

verged Network Adapter card manual for details on the installation method.

1.4

Use an editor such as "vi" to add the setting values to the configuration file.

Note that the setting values and details vary depending on the OS vender, version, whether the ETERNUS

Multipath Driver is used, and the storage system that is used.

Step 1

through

Step 6

shown here for each Converged Network Adapter card to be installed.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for Linux

Step

P3AM-6402-11ENZ0