Fujitsu Eternus DX90 S2 Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Fujitsu Eternus DX90 S2. Fujitsu Eternus DX90 S2 18 pages. Server connection. (fibre channel) for aix
Également pour Fujitsu Eternus DX90 S2 : Manuel de l'utilisateur (35 pages), Manuel de l'utilisateur (42 pages), Instal Setup (20 pages), Manuel de configuration Connexion au serveur (13 pages), Installation du matériel (23 pages), Manuel de configuration (28 pages), Manuel de configuration (15 pages), Manuel de configuration (38 pages)

Imprimer la page
Fujitsu Eternus DX90 S2 Manuel
Installation in a Rack
S T E P
The rack rail needs to be attached to the rack and the controller enclosure or the drive enclosure needs to be
installed.
-Installation- "Chapter 3 Rack Installation"
●
IMPORTANT
●
1.
Adjust the rack rail size to fit the rack.
[Left]
2.
Attach the rack rails to the rack.
The size of the controller enclosure and each drive enclosure is 2U.
Plate
M5 screws
(Front rack pillars)
The M5 screw positions for the rack rails are determined by the controller enclosure or the drive enclosure base
line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the 2nd and 5th
holes on the rear rack pillars above the base line to fasten the rack rails.
[Left]
6th position
(M5 centering screw)
1st position
(M5 pan head screw)
Drive enclosures must be installed above the controller enclosure. When installing multiple drive enclosures,
install them in the order of the "DE_No. label" numbers that are attached to the drive enclosures.
The DE_No. labels are attached on the following locations.
Right front side of the drive enclosure
DE_No. labels
The center of gravity must be taken into consideration to prevent a rack from toppling over. The controller
enclosure and drive enclosures should generally be installed from bottom to top to lower the center of
gravity and to ensure the safe use of racks.
[Right]
Rack rail (for left side)
Washers
Plate
M5 screws
Rack rail (for right side)
Front view
[Right]
(M5 centering screw)
2U
(M5 pan head screw)
Base line
Rack rails
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
Upper rear side of the drive enclosure
(Rear rack pillars)
M5 screws
M5 screws
Washers
[Left]
6th position
5th position
(M5 centering screw)
2U
2nd position
1st position
(M5 pan head screw)
8
Rear view
[Right]
5th position
(M5 centering screw)
2nd position
(M5 pan head screw)
Base line
Rack rails
P3AM-4872-11EN