Fujitsu D1170 Manuel technique - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel technique pour {nom_de_la_catégorie} Fujitsu D1170. Fujitsu D1170 22 pages. Mainboard

Important notes
The shipped version of this board complies with the requirements of the EEC
directive 89/336/EEC "Electromagnetic compatibility".
Compliance was tested in a typical PC configuration.
When installing the board, refer to the specific installation information in the
Operating Manual or Technical Manual for the receiving device.
Connecting cables for peripherals must be adequately shielded to avoid interference.
Components can become very hot during operation. Ensure you do not touch
!
components when making extensions to the system board. There is a danger of burns!
The warranty is invalidated if the device is damaged during the installation or
i
replacement of system expansions. Information on which system expansions you can
use is available from your sales outlet or the customer service centre.

Information about boards

To prevent damage to the system board or the components and conductors on it, please take great
care when you insert or remove boards. Take great care to ensure that extension boards are slotted
in straight, without damaging components or conductors on the system board, or any other
components, for example EMI spring contacts.
Be especially careful with the locking mechanisms (catches, centring pins etc.) when you replace
the system board or components on it, for example memory modules or processors.
Never use sharp objects (screwdrivers) for leverage.
2 - English
Boards with electrostatic sensitive devices (ESD) are identifiable by the
label shown.
When you handle boards fitted with ESDs, you must, under all
circumstances, observe the following points:
·
You must always discharge static build up (e.g. by touching a
grounded object) before working.
·
The equipment and tools you use must be free of static charges.
·
Remove the power plug from the mains supply before inserting or
removing boards containing ESDs.
·
Always hold boards with ESDs by their edges.
·
Never touch pins or conductors on boards fitted with ESDs.
A26361-D1170-Z120-5-7419