Fujitsu D1170 Manual técnico - Página 10

Procurar online ou descarregar pdf Manual técnico para Placa-mãe Fujitsu D1170. Fujitsu D1170 22 páginas. Mainboard

Important notes

The shipped version of this board complies with the requirements of the EEC

directive 89/336/EEC "Electromagnetic compatibility".

Compliance was tested in a typical PC configuration.

When installing the board, refer to the specific installation information in the

Operating Manual or Technical Manual for the receiving device.

Connecting cables for peripherals must be adequately shielded to avoid interference.

Components can become very hot during operation. Ensure you do not touch

components when making extensions to the system board. There is a danger of burns!

The warranty is invalidated if the device is damaged during the installation or

replacement of system expansions. Information on which system expansions you can

use is available from your sales outlet or the customer service centre.

Information about boards

To prevent damage to the system board or the components and conductors on it, please take great

care when you insert or remove boards. Take great care to ensure that extension boards are slotted

in straight, without damaging components or conductors on the system board, or any other

components, for example EMI spring contacts.

Be especially careful with the locking mechanisms (catches, centring pins etc.) when you replace

the system board or components on it, for example memory modules or processors.

Never use sharp objects (screwdrivers) for leverage.

2 - English

Boards with electrostatic sensitive devices (ESD) are identifiable by the

label shown.

When you handle boards fitted with ESDs, you must, under all

circumstances, observe the following points:

You must always discharge static build up (e.g. by touching a

grounded object) before working.

The equipment and tools you use must be free of static charges.

Remove the power plug from the mains supply before inserting or

removing boards containing ESDs.

Always hold boards with ESDs by their edges.

Never touch pins or conductors on boards fitted with ESDs.

A26361-D1170-Z120-5-7419