Kohler K-1018 Manuel d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Kohler K-1018. Kohler K-1018 40 pages. Shower modules and receptors
Également pour Kohler K-1018 : Manuel du propriétaire (8 pages)

Imprimer la page

Back Side Shown

C-Clamp

3. Locate Wall Jambs

NOTE: Before proceeding, install the valving in the framing pocket.

- Position the walls upright on a clean, flat surface with the flanges mating as shown.

- Clamp the walls together at the top and bottom using C-clamps. Make sure the top and bottom edges are flush.

- Mark the location of the holes on the flange with a felt tip marker.

- Drill holes through both flanges with a 5/16" bit at the marked locations.

- Apply a minimum 1/4" (6mm) bead of caulk on one of the mating surfaces between the walls as shown.

- Assemble the bolt, washers, and nut at each location.

- Wrench tighten. Do not overtighten.

1024937-2-

25-1/2"

3" (7.6cm)

(64.8cm)

47-1/2"

(120.7cm)

Back Side Shown

Bolt

Washer

70"

(177.8cm)

Nut

Lockwasher

Washer

Apply

caulk/sealant

here

Kohler Co.