Kohler SV810-840 Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Kohler SV810-840. Kohler SV810-840 20 pages. Vertical crankshaft
Également pour Kohler SV810-840 : Manuel du propriétaire (21 pages), Manuel du propriétaire (21 pages)
Imprimer la page
Change the oil and oil filter as follows.
1. The drain plug is located on the starter side of the
oil pan. See Figure 8. Clean the area around the
oil drain plug and the oil fill cap/dipstick.
2. Remove the drain plug and the oil fill cap/
dipstick.
3. Allow the oil to drain and then reinstall the drain
plug. Tighten 13.6 N.m (10 ft. lb.).
4. Remove the old filter and wipe off the filter
adapter
with a clean cloth.
.
Place a new replacement
filter in a shallow pan
with the open end up. Pour new oil, of the proper
type, in through
the threaded
center hole. Stop
pouring
when the oil reaches the bottom of the
threads. Allow a minute or two for the oil to be
absorbed
by the filter material.
6. Apply a thin film of clean oil to the rubber gasket
on the new oil filter.
7.
Install the new oil filter to the filter adapter. Hand
tighten the filter until the rubber
gasket contacts
tile adapter,
then tighten the filter an additional
3/4-1 turn.
8. Fill the engine with the proper
oil to tile FULL or
"F" mark on the dipstick. Always check the oil
level with the dipstick
before adding more oil.
9. Reinstall the oil fill cap/dipstick
and tighten
securely.
10. Start the engine and check for oil leaks. Recheck
oil level before placing the engine into service.
Stop the engine, correct any leaks, and allow a
minute for the oil to drain down, then recheck the
level on the dipstick.
NOTE:
To prevent
extensive engine wear or damage,
always maintain
the proper
oil level in the
crankcase.
Never operate the engine with
tile oil level above tile "F" or FULL mark, or
below the "L" or LOW mark on the dipstick.
Service Precleaner
and Air Cleaner
Element
These engines
are equipped
with a replaceable,
high
density paper air cleaner element. Some engines are
also equipped
with an oiled, foam precleaner
which
surrounds
the paper element.
See Figures 10 and
11. Two different
capacity air cleaner systems are
available.
Check the air cleaner daily or before starting
the
engine.
Check for a buildup
of dirt and debris around
the air cleaner system. Keep this area clean. Also check
for loose or damaged
components.
Replace all bent or
damaged
air cleaner components.
NOTE:
Operating
the engine with loose or damaged
air cleaner components
could allow unfiltered
air into the engine causing premature
wear
and failure.
Precleaner (Some Models'
Figure 10. Courage Air Cleaner System.
Element (Taller)
Latch
Door
Figure 11. Courage
PRO Air Cleaner System.
Figure 12. Unhooking
Latch (Courage).