Aqua Control SELECT Series 2 Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Aqua Control SELECT Series 2. Aqua Control SELECT Series 2 19 pages. Display aerator

Imprimer la page

Remove the unit and hardware package from its box.

Inspect the motor lead and connector for any shipping

damage.

Remove the (3) three bolts with the cap nuts and lock

washers from the bottom holes in the head.

Remove the head from the upper tube.

Slide the float over the upper tube, flat side of float

toward the lower pump, lining up the key way in the

center of the float with the key on the upper tube.

Open the hardware package and remove the (2) two

large eye bolts. The eye bolts need the hex nut screwed

all the way on with the lock washer next and the flat

washer last.

Attach the two eye bolts to the underside of the float.

Slide the head over the upper tube, lining up the holes.

Replace the hardware with the head of the bolt on the

inside of the upper tube and the lock washer and cap

nut on the outside of the head.

If this is a saltwater unit, all of the threaded inserts

in the float are plugged by the factory during assembly

except under the eye bolts. If the unit has lights, remove

the rubber washer and then attach the brackets (pg 6),

replacing the rubber washer between the bracket and

the float. Plug any remaining inserts with the weight

pins or the 1/2" screws, lock washers, flat washers and

rubber washers. The rubber washer always goes

between the insert and the hardware.

10. Attach the tip rope between the larger hole on the suction

screen and one of the eye bolts attached to the bottom of

the float.

11. The float has 12 finger pockets molded into the underside

for lifting and carrying the assembled unit.

12. See the nozzle and light set instructions for attaching these

to the unit.

VERTICAL DISPLAY AERATOR & TORRENT ASSEMBLY

Aqua Control, Inc. 60 Hz. Select Series 2 Instruction Manual

SELECT SERIES 2