- ページ 2
芝生とガーデン用品 Aqua Control SELECT Series 2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Control SELECT Series 2 19 ページ。 Display aerator
ページを印刷する1.
Remove the unit and hardware package from its box.
2.
Inspect the motor lead and connector for any shipping
damage.
3.
Remove the (3) three bolts with the cap nuts and lock
washers from the bottom holes in the head.
4.
Remove the head from the upper tube.
5.
Slide the float over the upper tube, flat side of float
toward the lower pump, lining up the key way in the
center of the float with the key on the upper tube.
6.
Open the hardware package and remove the (2) two
large eye bolts. The eye bolts need the hex nut screwed
all the way on with the lock washer next and the flat
washer last.
7.
Attach the two eye bolts to the underside of the float.
8.
Slide the head over the upper tube, lining up the holes.
Replace the hardware with the head of the bolt on the
inside of the upper tube and the lock washer and cap
nut on the outside of the head.
9.
If this is a saltwater unit, all of the threaded inserts
in the float are plugged by the factory during assembly
except under the eye bolts. If the unit has lights, remove
the rubber washer and then attach the brackets (pg 6),
replacing the rubber washer between the bracket and
the float. Plug any remaining inserts with the weight
pins or the 1/2" screws, lock washers, flat washers and
rubber washers. The rubber washer always goes
between the insert and the hardware.
10. Attach the tip rope between the larger hole on the suction
screen and one of the eye bolts attached to the bottom of
the float.
11. The float has 12 finger pockets molded into the underside
for lifting and carrying the assembled unit.
12. See the nozzle and light set instructions for attaching these
to the unit.
2
VERTICAL DISPLAY AERATOR & TORRENT ASSEMBLY
Aqua Control, Inc. 60 Hz. Select Series 2 Instruction Manual
SELECT SERIES 2