Aqua Creek Revolution Deep F-702RLNA-DD Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aqua Creek Revolution Deep F-702RLNA-DD. Aqua Creek Revolution Deep F-702RLNA-DD 14 pages. Draft lift

Imprimer la page

Revolution Deep Draft Assembly Instructions

CONTROL ARM

LIFTING ARM

3/8" NYLOCK

NUT (2)

STEP 5: ADJUST THE SEAT POSITION

The SEAT ASSEMBLY will arrive attached to the SEAT ARM

adjusted to its highest position. To adjust the SEAT ASSEMBLY

to a lower position remove the hardware as shown below.

Slide the SEAT ASSEMBLY to its desired position (in 4 inch

increments) and reinstall the hardware. The maximum

adjustment is 16 inch (down).

DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS

– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE

SEAT ASSEMBLY TO THE CHAIR ARM!

NOTE: For most applications, such as pools with a ﬂ at deck,

the seat will be installed in its lowest position. For applications

where a wall or curb must be cleared the seat should be

installed in a higher position. In its highest position the seat

will clear a 24 inch [609mm] high wall (with the pull-out

legrest).

3/8" X 2"

SHOULDER BOLT

5/16" X 4 1/2"

HEX BOLT

STEP 4

3/8" FLAT

WASHER (2)

DEEP DRAFT

SEAT ARM

STEP 4: INSTALL SEAT ARM

Locate the SEAT ARM and the following hardware:

• (2) 1/2" x 3" SHOULDER BOLT

• (2) 3/8" FLAT WASHER

• (2) 3/8" NYLOCK NUT

Install the SEAT ARM at the ends of the CONTROL

ARM and LIFTING ARM as shown in the ﬁ gure to the

left. Tighten the NYLOCK NUTS until snug as shown in

1/2" X 3"

SHOULDER

PHOTO 4. DO NOT OVERTIGHTEN!

BOLT (2)

(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM

THE MAIN ASSEMBLY)

NOTE: FOR APPLICATIONS THAT UTILIZE MULTIPLE

SEAT ARMS (SUCH AS FOR A SLING SEAT OR THE SPA

SEAT-ARM) USE THIS STEP TO REMOVE AND REPLACE

THE SEAT ARM.

SEAT-ARM

HOLES AT 4"

INTERVALS

ALLOW FOR

ADJUSTMENT

OVER 16"

RANGE

SEAT ASSEMBLY

ADJUSTED TO

LOWEST POSITION

(SEAT WILL ARRIVE

AT HIGHEST

POSITION)

STEP 5

5/16" FLAT

WASHER (3)

5/16" NYLOCK

NUT (2)

MAIN

ASSEMBLY

Revised 6/25/20