Aqua Creek Revolution Deep F-702RLNA-DD 매뉴얼 - 페이지 8
{카테고리_이름} Aqua Creek Revolution Deep F-702RLNA-DD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Revolution Deep F-702RLNA-DD 14 페이지. Draft lift
Revolution Deep Draft Assembly Instructions
CONTROL ARM
LIFTING ARM
3/8" NYLOCK
NUT (2)
STEP 5: ADJUST THE SEAT POSITION
The SEAT ASSEMBLY will arrive attached to the SEAT ARM
adjusted to its highest position. To adjust the SEAT ASSEMBLY
to a lower position remove the hardware as shown below.
Slide the SEAT ASSEMBLY to its desired position (in 4 inch
increments) and reinstall the hardware. The maximum
adjustment is 16 inch (down).
DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS
– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE
SEAT ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications, such as pools with a fl at deck,
the seat will be installed in its lowest position. For applications
where a wall or curb must be cleared the seat should be
installed in a higher position. In its highest position the seat
will clear a 24 inch [609mm] high wall (with the pull-out
legrest).
3/8" X 2"
SHOULDER BOLT
5/16" X 4 1/2"
HEX BOLT
8
Copyright © 2020 Aqua Creek Products All Rights Reserved
STEP 4
3/8" FLAT
WASHER (2)
DEEP DRAFT
SEAT ARM
STEP 4: INSTALL SEAT ARM
Locate the SEAT ARM and the following hardware:
• (2) 1/2" x 3" SHOULDER BOLT
• (2) 3/8" FLAT WASHER
• (2) 3/8" NYLOCK NUT
Install the SEAT ARM at the ends of the CONTROL
ARM and LIFTING ARM as shown in the fi gure to the
left. Tighten the NYLOCK NUTS until snug as shown in
1/2" X 3"
SHOULDER
PHOTO 4. DO NOT OVERTIGHTEN!
BOLT (2)
(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM
THE MAIN ASSEMBLY)
NOTE: FOR APPLICATIONS THAT UTILIZE MULTIPLE
SEAT ARMS (SUCH AS FOR A SLING SEAT OR THE SPA
SEAT-ARM) USE THIS STEP TO REMOVE AND REPLACE
THE SEAT ARM.
SEAT-ARM
HOLES AT 4"
INTERVALS
ALLOW FOR
ADJUSTMENT
OVER 16"
RANGE
SEAT ASSEMBLY
ADJUSTED TO
LOWEST POSITION
(SEAT WILL ARRIVE
AT HIGHEST
POSITION)
STEP 5
5/16" FLAT
WASHER (3)
5/16" NYLOCK
NUT (2)
MAIN
ASSEMBLY
Revised 6/25/20