Dexter Laundry WCVD-WN Series Manuel de programmation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de programmation pour {nom_de_la_catégorie} Dexter Laundry WCVD-WN Series. Dexter Laundry WCVD-WN Series 6 pages. Opl washers
Également pour Dexter Laundry WCVD-WN Series : Preventative Maintenance (2 pages)
Imprimer la page
Rapid Advance Mode
To enter the Rapid Advance mode, turn the key CCW. The Rapid Advance setting is not marked next to
the key, but turning the CCW until it stops selects this mode. The Rapid Advance mode can be entered
from either the Idle mode or during the cycle. If the cycle has not yet started, press the "START" button.
To rapid advance to the next step in the wash cycle, push both the "UP" and "START" buttons at the same
time. The display will show an "Ad" (advance) in the display. The washer will advance to the next bath
segment. The water will drain before the advance will occur and the time displayed may not be accurate.
Notes:
- The indicator lights will show to which segment the cycle has been advanced.
- The cycle will continue in rapid advance mode even if the key is turned to "RUN" and/
or removed.
- Rapid advance cannot skip the final 1- minute tumble of the cycle, and the door
lock may remain activated for up to 3 minutes after the cycle has been completed.
- Chemical 120 volt signals will be lost after Rapid advance Mode has been activated
until cycle resets. To exit the Rapid Advance mode, push and hold the STOP button.
Injection Source Details
The washer control may be programmed to send
output signals for a chemical injection system.
There is a separate terminal block for connection
of the external injection signals. For the injection
sources, program codes 0 through 6 are as shown
in the table below. Injection signal will trigger a 120
volt reading at rear terminal block for approximately
5-10 seconds and will start to trigger at about 10-
seconds
after start of fi ll bath.
Dexter
Recommended Connections
Circuits
Detergent
Bleach
Starch
Sour/Softener
NOTE: The Wash Cycle programming mode will automatically exit and return to the Idle
mode if no buttons are pushed for one minute.
6
Part # 8533-075-001 6/13
Controller
Programmed Signals
1
2
3
4
5
6
0
15
Injection
Terminal Block
A
B
C
D
A and B
C and D
None