Dexter Laundry WCVD-WN Series 프로그래밍 매뉴얼 - 페이지 6

{카테고리_이름} Dexter Laundry WCVD-WN Series에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry WCVD-WN Series 6 페이지. Opl washers
Dexter Laundry WCVD-WN Series에 대해서도 마찬가지입니다: 예방적 유지 관리 (2 페이지)

페이지 인쇄

Rapid Advance Mode

To enter the Rapid Advance mode, turn the key CCW. The Rapid Advance setting is not marked next to

the key, but turning the CCW until it stops selects this mode. The Rapid Advance mode can be entered

from either the Idle mode or during the cycle. If the cycle has not yet started, press the "START" button.

To rapid advance to the next step in the wash cycle, push both the "UP" and "START" buttons at the same

time. The display will show an "Ad" (advance) in the display. The washer will advance to the next bath

segment. The water will drain before the advance will occur and the time displayed may not be accurate.

Notes:

- The indicator lights will show to which segment the cycle has been advanced.

- The cycle will continue in rapid advance mode even if the key is turned to "RUN" and/

or removed.

- Rapid advance cannot skip the final 1- minute tumble of the cycle, and the door

lock may remain activated for up to 3 minutes after the cycle has been completed.

- Chemical 120 volt signals will be lost after Rapid advance Mode has been activated

until cycle resets. To exit the Rapid Advance mode, push and hold the STOP button.

Injection Source Details

The washer control may be programmed to send

output signals for a chemical injection system.

There is a separate terminal block for connection

of the external injection signals. For the injection

sources, program codes 0 through 6 are as shown

in the table below. Injection signal will trigger a 120

volt reading at rear terminal block for approximately

5-10 seconds and will start to trigger at about 10-

seconds

after start of ﬁ ll bath.

Dexter

Recommended Connections

Circuits

Detergent

Bleach

Starch

Sour/Softener

NOTE: The Wash Cycle programming mode will automatically exit and return to the Idle

mode if no buttons are pushed for one minute.

Part # 8533-075-001 6/13

Controller

Programmed Signals

Injection

Terminal Block

A and B

C and D

None