BilJax Multi-Stage AS-2100 Manuel d'instructions de montage - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} BilJax Multi-Stage AS-2100. BilJax Multi-Stage AS-2100 8 pages. Deck surface
Également pour BilJax Multi-Stage AS-2100 : Comment remplacer (9 pages)
Imprimer la page
Step 10
Stairs
Each set of stairs requires a T-Lock adapter to secure the stairs to the Multi-Stage. To begin, attach the T-Lock adapter to
the stair assembly using the bolts provided.
To install stairs:
A. Set the lower lip of the lock inside the C-Channel along the perimeter of the Multi-Stage.
B. Swing the stairs assembly up until the T-Lock is fully seated within the C-Channel of the stage. Press down on
plunger if necessary to seat T-Lock.
C. Extend the stairs section so that the end opposite the stage is touching the ground.
D. Fully tighten the wing nut attached to the banana clip on each side of the stairs.
E. Tighten the hex nut attached to each T-Lock to 50 ft-lb.
F. Install handrails.
G. To remove stairs section, loosen the wing nut attached to the banana clip, loosen the hex nut and depress
plunger to release T-Lock.
WARNING
Failure to correctly install stairs could result in serious injury or
death. Verify that each T-Lock is fully seated inside the Multi-Stage,
as shown in Figure B, and stair section is secure. T-Lock will click
audibly when it is installed.
7