- ページ 7

屋外用家具 BilJax Multi-Stage AS-2100のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。BilJax Multi-Stage AS-2100 8 ページ。 Deck surface
BilJax Multi-Stage AS-2100 にも：交換方法 (9 ページ)

ページを印刷する

Step 10

Stairs

Each set of stairs requires a T-Lock adapter to secure the stairs to the Multi-Stage. To begin, attach the T-Lock adapter to

the stair assembly using the bolts provided.

To install stairs:

A. Set the lower lip of the lock inside the C-Channel along the perimeter of the Multi-Stage.

B. Swing the stairs assembly up until the T-Lock is fully seated within the C-Channel of the stage. Press down on

plunger if necessary to seat T-Lock.

C. Extend the stairs section so that the end opposite the stage is touching the ground.

D. Fully tighten the wing nut attached to the banana clip on each side of the stairs.

E. Tighten the hex nut attached to each T-Lock to 50 ft-lb.

F. Install handrails.

G. To remove stairs section, loosen the wing nut attached to the banana clip, loosen the hex nut and depress

plunger to release T-Lock.

WARNING

Failure to correctly install stairs could result in serious injury or

death. Verify that each T-Lock is fully seated inside the Multi-Stage,

as shown in Figure B, and stair section is secure. T-Lock will click

audibly when it is installed.