Aqua Mundus GreaseShield 1850 AST Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aqua Mundus GreaseShield 1850 AST. Aqua Mundus GreaseShield 1850 AST 2 pages.

Imprimer la page
Installation Guide - GreaseShield
"
0
Ensure that there is sufficient clearance above and to the right of the unit for servicing purposes
GS1850 AST Unit:
e
(5.9"/150mm minimum).
e
Inlet Pipe - 1½"/40mm:
Outlet Pipe - 2"/54mm:
0
Invert Inlet - 1¼"/32mm:
FlexiPlumb adaptor may be required. Should be capped off with a
0
Decant Outlet Hose - ¾"/18mm:
The Hose must be fixed in place using the drainage hose support provided.
Connected to the outlet of the unit; it is essential in the analysis of effluent leaving the unit.
Sampling Point:
The outlet of unit must be fitted with a running trap to reduce foul smells.
Running Trap:
Ensure that the container is not restricted or blocked for daily maintenance.
FOG Container:
Ensure that the container is not restricted or blocked for daily maintenance.
Solids Container:
Hot Water Solenoid Valve:
supply must not exceed
used. Mains water connections must be made via a WRAS approved isolation valve which follows a WRAS approved double
check valve.
The unit must be plugged into a
Power Lead:
Interconnecting Pipework:
Stainless Steel Hygiene Stand (Optional Extra):
stand. It can be adjusted up to
for cleaning.
Award Winning Technology
To be piped with a sufficient fall of no less than 1 in 40.
To be piped with a sufficient fall of no less than 1 in 40.
For gravity drained dishwashers use the invert inlet. A
To be piped directly into the main drainage pipe via a vented drainage stack as shown.
Hot water must be connected to the unit using the ¾"
pressure and
3 bar
60
C/140
°
13 amp
All pipework must be clipped and properly supported.
GS1850 AST unit should be installed on a Stainless Steel Hygiene
in height to allow the unit to be levelled on uneven surfaces and provide access
2"/50mm
1850 AST
®
FlexiPlumb Endcap when not in use.
1¼"/32mm
In the case of high pressure a pressure reducing valve must be
F.
°
rated
socket located below counter level.
IP56
0
1¼"/32mm to 1½"/40mm
Red PVC Hose provided, water
BSP {F/F)
Web: www.aquamundus.com Phone
number 01386832205 Email:
()
)
vs 04/02/2020