Avonic CM-CON100 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avonic CM-CON100. Avonic CM-CON100 16 pages. Ptz camera controller
Également pour Avonic CM-CON100 : Manuel de l'utilisateur (12 pages), Manuel de l'utilisateur (10 pages), Manuel de l'utilisateur (13 pages), Manuel de l'utilisateur (11 pages)

RS485 network connection diagram

To connect multiple cameras by RS485, the cameras are attached to a 2-wire twisted pair bus (max length

1200m) that is terminated at both ends with a 120 Ω impedance resistor. The maximum distance from the bus

to the camera or controller is 5m.

In case more cameras are connected to the controller, each camera needs to be addressed the right way to a

camera number of the controller.

The following settings need to match in both camera and controller:

Protocol (VISCA, PELCO-p or PELCO-d)

Camera address number (1, 2 or n)

Communication settings as baud rate (9600), parity, etc.

See page 12 (Camera Settings) for more information. The following section of this manual describes how to set

up the controller.