Aqua Quip EVO2 LED Instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Aqua Quip EVO2 LED. Aqua Quip EVO2 LED 4 pages.
Imprimer la page
Adjustable Dress Ring Installation –
After Concreting and Sealing (Diagram 2)
7 Remove red-coloured Concrete Cap. Use pvc glue or
construction adhesive to secure the Adjustable Dress
Ring inside the Housing to your required depth and
alignment. If Housing protrudes out from the concrete,
a maximum of 20mm can be cut off from the front. If
the housing has been set back too far in the wall, then
a special extension ring (P/N ASL 076) is available. The
eyeball feature on the Adjustable Dress Ring allows
adjustment so that the Adjustable Dress Ring face can
be aligned flush with the anticipated pool interior finish
even if the Housing is out of alignment. When gluing or
securing the Adjustable Dress Ring, ensure that 2 of the
screw holes are located horizontally.
8 Evo2 Cable can be drawn through, excess cable must
be coiled up and stored inside Housing. The Connector
Cap must remain on end of Quick Connect Plug Kit.
Important: Allow enough cable to enable pool light to
be floated to pool deck.
Cable Seal Assembly is factory-fitted onto the black
cable. Slide the Cable Clamp, Seal, Washer and Cable
Nut up the cable and tighten onto the male thread that is
fixed to the inside of the Housing. This will prevent water
entering the conduit.
9 The Adjustable Dress Ring is now in position ready
for the pool interior to be applied. Push on the green-
coloured Plaster Cap into the Adjustable Dress Ring
by lining up the arrows on the Plaster Cap with the
screw provisions on the Adjustable Dress Ring, push in
firmly. Pool interior should finish flush with the front face
of the Adjustable Dress Ring .
AQUA-QUIP EVO2 LED QUICK CONNECT PLUG KIT
Protective
Connector
Cap
The Evo2 LED pool light cable is 2-core, 1mm² cable with an outer diameter of ±7mm.
It is supplied factory fitted with the Quick Connect Plug Kit and Protective Connector Cap. This allows the installer/
builder to install the cable and build the pool without the need to connect the pool light until just prior to filling.
The cable is also supplied factory fitted with the Cable Seal Assembly. The components of the Cable Seal Assembly
will slide up the cable, tighten and seal onto the male thread that is fixed to the inside of the housing, preventing pool
water from entering the conduit.
E V O 2 L E D L I G H T S F O R C O N C R E T E P O O L S – I N S T A L L A T I O N I N S T R U C T I O N S
EVO2 LED
DRESS RING INSTALLATION
Quick
Connect
Plug Kit
LIGHTS FOR
CONCRETE POOLS
Construction
Adhesive Seal
Concrete
Diagram 2 – Sealing
Cable Seal Assembly
Adjustable
Dress Ring
Installed
and
Sealed
Interior
Pool Wall
Finish
3