Aqua Quip EVO2 LED Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Pencahayaan Kolam Renang Aqua Quip EVO2 LED. Aqua Quip EVO2 LED 4 halaman.

Halaman Cetak

Adjustable Dress Ring Installation –

After Concreting and Sealing (Diagram 2)

7 Remove red-coloured Concrete Cap. Use pvc glue or

construction adhesive to secure the Adjustable Dress

Ring inside the Housing to your required depth and

alignment. If Housing protrudes out from the concrete,

a maximum of 20mm can be cut off from the front. If

the housing has been set back too far in the wall, then

a special extension ring (P/N ASL 076) is available. The

eyeball feature on the Adjustable Dress Ring allows

adjustment so that the Adjustable Dress Ring face can

be aligned ﬂush with the anticipated pool interior ﬁnish

even if the Housing is out of alignment. When gluing or

securing the Adjustable Dress Ring, ensure that 2 of the

screw holes are located horizontally.

8 Evo2 Cable can be drawn through, excess cable must

be coiled up and stored inside Housing. The Connector

Cap must remain on end of Quick Connect Plug Kit.

Important: Allow enough cable to enable pool light to

be ﬂoated to pool deck.

Cable Seal Assembly is factory-ﬁtted onto the black

cable. Slide the Cable Clamp, Seal, Washer and Cable

Nut up the cable and tighten onto the male thread that is

ﬁxed to the inside of the Housing. This will prevent water

entering the conduit.

9 The Adjustable Dress Ring is now in position ready

for the pool interior to be applied. Push on the green-

coloured Plaster Cap into the Adjustable Dress Ring

by lining up the arrows on the Plaster Cap with the

screw provisions on the Adjustable Dress Ring, push in

ﬁrmly. Pool interior should ﬁnish ﬂush with the front face

of the Adjustable Dress Ring .

AQUA-QUIP EVO2 LED QUICK CONNECT PLUG KIT

Protective

Connector

Cap

The Evo2 LED pool light cable is 2-core, 1mm² cable with an outer diameter of ±7mm.

It is supplied factory fitted with the Quick Connect Plug Kit and Protective Connector Cap. This allows the installer/

builder to install the cable and build the pool without the need to connect the pool light until just prior to filling.

The cable is also supplied factory fitted with the Cable Seal Assembly. The components of the Cable Seal Assembly

will slide up the cable, tighten and seal onto the male thread that is fixed to the inside of the housing, preventing pool

water from entering the conduit.

E V O 2 L E D L I G H T S F O R C O N C R E T E P O O L S – I N S T A L L A T I O N I N S T R U C T I O N S

EVO2 LED

DRESS RING INSTALLATION

Quick

Connect

Plug Kit

LIGHTS FOR

CONCRETE POOLS

Construction

Adhesive Seal

Concrete

Diagram 2 – Sealing

Cable Seal Assembly

Adjustable

Dress Ring

Installed

and

Sealed

Interior

Pool Wall

Finish