CPG 351COHT4M Manuel de l'utilisateur - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} CPG 351COHT4M. CPG 351COHT4M 14 pages. Electric countertop convection ovens

Imprimer la page

User Manual

Warning and Alarms

All alarms are indicated by a buzzer . The buzzer can be silenced by pressing a key .

•

ERR = CHAMBER PROBE ALARM

This is triggered if the chamber probe fails . Everything is deactivated except for the light . The cycle in

progress is interrupted . Once the alarm is silenced, press the ON/OFF button for 1 second to reset the

alarm (the control panel is set to OFF) .

•

"ALL" = MOTOR ALARM

This is triggered if the motor overheats . Everything is deactivated except for the light . The cycle in

progress is interrupted . Once the alarm is silenced, press the ON/OFF button for 1 second to reset the

alarm (the control panel is set to OFF) .

•

"H-t" = CONTROL BOARD TEMPERATURE ALARM

This is triggered if the control board overheats . The cycle in progress is interrupted . Once the alarm is

silenced, press the ON/OFF button for 1 second to reset the alarm (the control panel is set to OFF) .

Operator and Factory Parameters Table

Parameter

P01

P03

P06

(% value of the set above the cooking setpoint)

Light Mode: 0= timed on button pressure, 1= always

P15

P16

P17

P40

Time of inactivity to switch to standy mode

P52

Access the parameter menu with the oven set to "OFF", indicated by the top display of the

appliance . Press down the ' ' key until the upper display shows "PAS" and the lower display shows "0",

flashing. Press the '+' key to set the value shown on the lower display to "30". Confirm by pressing

START/STOP . The upper display will show the name of the parameter, whereas the lower one will show

the value of that parameter . Scroll through the list of editable parameters using the '+' and '-' buttons .

Once the parameter to be edited has been found, press the START/STOP button: the value shown on the

lower display will start to flash, and then press '+' and '-' but tons to change the value . Once the desired

value has been set, according to the table below, press START/STOP to confirm the change. When the

desired parameters have been changed, press the ' ' key to set the appliance back to "OFF" .

Description

Temperature unit: 0=C, 1=F

Min . cooking temperature setpoint

Preheating superheating

ON during cooking, 2= Always ON

Light activation time

Enable Preheating

Default Setpoint for Cooling

(function disabled with 0)

Default

Limits

Unit

Value

0-1

Flag

30-200

C/F

0-100

0-2

Flag

0-120

Seconds

0-1

Flag

30-70

C/F

0-60

Minutes

www.cookingperformancegroup.com

Level

Operator

Factory

Operator

Factory