CPG 351COHT4M Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Конвекционная печь CPG 351COHT4M. CPG 351COHT4M 14 страниц. Electric countertop convection ovens

Печатать страницу
User Manual
Warning and Alarms
All alarms are indicated by a buzzer . The buzzer can be silenced by pressing a key .
•
ERR = CHAMBER PROBE ALARM
This is triggered if the chamber probe fails . Everything is deactivated except for the light . The cycle in
progress is interrupted . Once the alarm is silenced, press the ON/OFF button for 1 second to reset the
alarm (the control panel is set to OFF) .
•
"ALL" = MOTOR ALARM
This is triggered if the motor overheats . Everything is deactivated except for the light . The cycle in
progress is interrupted . Once the alarm is silenced, press the ON/OFF button for 1 second to reset the
alarm (the control panel is set to OFF) .
•
"H-t" = CONTROL BOARD TEMPERATURE ALARM
This is triggered if the control board overheats . The cycle in progress is interrupted . Once the alarm is
silenced, press the ON/OFF button for 1 second to reset the alarm (the control panel is set to OFF) .
Operator and Factory Parameters Table
Parameter
P01
P03
P06
(% value of the set above the cooking setpoint)
Light Mode: 0= timed on button pressure, 1= always
P15
P16
P17
P40
Time of inactivity to switch to standy mode
P52
Access the parameter menu with the oven set to "OFF", indicated by the top display of the
appliance . Press down the ' ' key until the upper display shows "PAS" and the lower display shows "0",
flashing. Press the '+' key to set the value shown on the lower display to "30". Confirm by pressing
START/STOP . The upper display will show the name of the parameter, whereas the lower one will show
the value of that parameter . Scroll through the list of editable parameters using the '+' and '-' buttons .
Once the parameter to be edited has been found, press the START/STOP button: the value shown on the
lower display will start to flash, and then press '+' and '-' but tons to change the value . Once the desired
value has been set, according to the table below, press START/STOP to confirm the change. When the
desired parameters have been changed, press the ' ' key to set the appliance back to "OFF" .
12
Description
Temperature unit: 0=C, 1=F
Min . cooking temperature setpoint
Preheating superheating
ON during cooking, 2= Always ON
Light activation time
Enable Preheating
Default Setpoint for Cooling
(function disabled with 0)
Default
Limits
Unit
Value
0
0-1
Flag
30
30-200
C/F
20
0-100
%
2
0-2
Flag
45
0-120
Seconds
1
0-1
Flag
50
30-70
C/F
10
0-60
Minutes
www.cookingperformancegroup.com
.
Level
Operator
Factory
Operator
Operator
Operator
Operator
Operator
Factory