CPS IAQPRO SmartAir Manuel de démarrage rapide et de dépannage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide et de dépannage pour {nom_de_la_catégorie} CPS IAQPRO SmartAir. CPS IAQPRO SmartAir 8 pages. Professional indoor air quality meter
Également pour CPS IAQPRO SmartAir : Manuel du propriétaire (18 pages), Manuel du propriétaire (9 pages)

CPS IAQPRO SmartAir Manuel de démarrage rapide et de dépannage
AIR QUALITY (Issues, Causes, Solutions) Cont'd
Indoor Air Quality
Issues
In the summer, conden-
sation forms on ducts, air
High Or Low Dew
diffusers, walls or ceilings
Point
In the winter, condensation
forms inside exterior walls

TROUBLESHOOTING GUIDE

Problem
Light Bar
Light bar doesn't turn on
What do light bar colors
indicate?
CPS Link App
CPS Link App crashes
Can't pair phone or tablet
to SmartAir

Remote Operation

Can't connect with mobile
device
Low Or High Temperature
Or Humidity Readings
6
Potential Causes
Ensure AC system is proper size (tons)
and functioning properly. Check ductwork
or building envelope for leaks. Determine
if insulation missing
Possible Solution
Ensure power cord plugged into wall outlet that is receiving power.
See label on back of SmartAir housing for color explanations (or see #
3b in Quick Start Instructions above)
Flashing Red- SmartAir is in start up mode.
Alternating Green/Red- SmartAir sensor baseline not set up. See "Set
tVOC Sensor Baseline" instructions.
Alternating Green/Yellow- Wait 5 to 60 minutes for tVOC sensor to
warm up.
Blue flash (once every 5 seconds): SmartAir is paired to your mobile
device with the CPS Link app.
Ensure mobile device is Bluetooth compatible, and Bluetooth setting
ON in mobile device
Delete the CPS Link app from your mobile device. Then reinstall the
latest CPS Link app (from App Store or Google Play) on your mobile
device
From App Store or Google Play, download the latest CPS Link app on
your mobile device and pair it to the SmartAir.
Mobile device must be ≤ 150 ft (46m) from CPS SmartAir
Reset SmartAir by unplugging and plug in. Then pair to mobile device
Mobile device must be ≤ 100 ft (30m) from SmartAir (direct line of
sight)
Charge mobile device battery
If SmartAir has been stored in temperature extremes, it must be
placed indoors, inplugged in NORMAL TEMPERATURE AND HUMIDITY
conditions for 6~8 hours before being powered ON.
Recommended Solutions
+
Recommended
Indoor Levels
OSHA recommends
24 to 60 °F (−4.5 to
15.5 °C)