CPS Products BLACKMAX MD100 Series Manuel du propriétaire - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} CPS Products BLACKMAX MD100 Series. CPS Products BLACKMAX MD100 Series 20 pages. Digital 2 and 4 valves

Imprimer la page

Find Quality Products Online at:

APPENDIX C (MDXBK CHARGER ACCESSORY SPECIFICATIONS)

Operating Temperature Range

Operating and Storage Humidity

Storage Temperature

Power Source

Battery Type

Rechargeable Battery Cycle Life

APPENDIX D (BATTERY SELECTION AND REPLACEMENT)

For optimum life and economic value, CPS Products, Inc. recommends that MD50 and MD100

manifold series be powered by rechargeable NiMH (nickel metal hydride) batteries. CPS Products

offers an optional "Charger Kit" (model MDXBK) that comes with a power adapter and 4 NiMH

batteries. Do not connect the battery charger if there are no rechargeable batteries in the manifolds.

NOTE: Alkaline batteries should not, and cannot be charged in the BLACKMAX MD50 or MD100

Series. Battery charge status is shown by the battery indicator symbol in the upper left [FIG.1]

Main Screen and all other screens. NOTE: A slight increase in temperature near the charging

socket is normal. Remove battery door and install 4 AA size batteries, observing battery polarity.

When using rechargeable batteries for the first

time, turn manifold off and connect one end

of charger to Manifold 9V DC plug [FIG.28]

and the other end to an appropriate wall outlet

socket. Charge NiMH batteries for 2 hours. The

Battery Symbol on the display will blink during

charging. MD50 and MD100 manifold series

can be used while charging the batteries, but

charging time will be considerably extended.

The preferred way to use the Rapid Charging

Feature is to charge while the manifold is OFF.

APPENDIX E (CLEANING SENSOR IN MDXVG)

Sensor may become contaminated with dust, oil, etc. from pulling vacuums.

1. Never use a cotton swab or similar object to clean the sensor. This may damage the

sensor.

2. Open all knobs, valves, and cap all the ports except for the VAC port.

3. Invert the MDXVG and add about 1 tablespoon of 100% denatured alcohol into the VAC port

(see FIG 2) so as to flush out contaminants.

4. Gently shake the unit to produce a swirling effect of the alcohol inside the housing.

5. Turn right side up, open a port to pour out the rubbing alcohol.

6. Repeat the above procedure until the alcohol appears to be clean and clear of contaminants.

7. Check the gasket located inside the VAC port. If worn or deformed, replace with a new CPS

gasket (PN: HXG)

8. Open all ports to allow sensors to air dry (usually about 1 hour). DO NOT BLOW DRY.

GlobalTestSupply

www.

32°F to 122°F (0°C to 50°C)

0-95%

-40°F to 185°F (-40 to 85°C)

100-240VAC input, 9VDC 2.0 amp maximum output

AA size, NiMH rechargeable, approximate battery life is 20,000 to

50,000 hours*

1000 recharges *based on usage with or without the LCD backlight

energized.

FIG.28

Connection

for 9V DC

Charger

.com

[email protected]